1 sec sample rate for BME688 BSEC2

[Al-Okby]

Dear colleagues, 
I have a question regarding changing the sample rate of the BME688 in BSEC2 library

In BSEC1 I simply use continuous Mode, in BSEC2 it is not very clear to me how to get 1 sec sample rate, if there is a simple code for this it will be much appreciated, thanks for help  

[BSTRobin]

Hello Al-Okby,

In BSEC2 integration guide, there was sample rate option table, you could set it in your code.

[Al-Okby]

 Hello BSTRobin, 
Thank you for helping me,

could you please help me in modifying the example of BSEC 2, what should I change to get a 1sec sample rate for IAQ instead of approximately 10 sec
I attached a copy of my serial monitor 
Best regards 

al-okby

[BSTRobin · Accepted solution]

Hello Al-Okby,

Sorry. After confirmation, the software architecture of BSEC2 does not support 1 Hz sample rate, while BSEC1 supports 1 Hz sample rate. So you could see BSEC2 software, 1 Hz sample rate code was removed.