09-17-2021 04:39 AM
1) Is there a schematic for Application Board 3.0?
2) Is there a recommended battery holder/battery for the board?
3) Do the holes in board at battery socket correspond to the polarity imprinted on the board near the holes?
4) Are the Interrupt pins from the IMU made available anywhere externally on the Application Board 3.0?
09-18-2021 09:05 AM
Hello Swingpro,
1: the schematic is not official release, customer can downlow the user guide from below link
https://www.bosch-sensortec.com/media/boschsensortec/downloads/software_tools/application_board_3_0/...
2:
battery holder: MOLEX - 0532540270
3: yes
4: the INT is available from the APP3.0 shuttle
09-18-2021 09:09 AM
Hello Swingpro,
1: the schematic is not official release, customer can downlow the user guide from below link
https://www.bosch-sensortec.com/media/boschsensortec/downloads/software_tools/application_board_3_0/...
2:
battery holder: MOLEX - 0532540270
3: yes
4: the INT is available from the APP3.0 shuttle
09-20-2021 06:03 PM - edited 09-20-2021 07:26 PM
Thanks - on the interrupt being made available - I see that the interrupt pins are part of the shuttle board connection but is there anywhere else on the board where those same interrupts pins can be accessed?
Also - the PN provided for Molex is the header connector. I was asking if there was a battery holder.
09-22-2021 03:33 AM
Hello Swingpro,
Interrupt pin on application board 3.0 and shuttle board was both described in applicatioon board 3.0 user guide and BMI270 shuttle board 3.0 document. Could you download and refer them?
applicatioon board 3.0 user guide
https://www.bosch-sensortec.com/media/boschsensortec/downloads/software_tools/application_board_3_0/...
BMI270 shuttle board 3.0
https://www.bosch-sensortec.com/media/boschsensortec/downloads/shuttle_board_flyer/application_board...
battery holder: MOLEX - 0532540270
https://item.taobao.com/item.htm?spm=a230r.1.14.58.55513d5byaYHXS&id=583314453069&ns=1&abbucket=10#d...