BHI260AP loading firmware into FLASH I can't do this

[uuranbey]

Hello, we can detect Flash. But I can't upload firmware to flash. So I can't boot from flash. I can also load firmware into RAM and boot from RAM. Can you help me? The flash I use is MX25R163FZIH0. I am using the sample euler software. Do I need to do something different for FLASH?
I enable #define UPLOAD_FIRMWARE_TO_FLASH.

[BSTRobin · Accepted solution]

Hi uuranbey,

The Flash MX25R163FZIH0 you are using was not found in MXIC official web site and should be a new part. The BHI260AP firmware does not support this part.
We have listed the Flash part supported by BHI260AP. You can use the Flash in the table.

[uuranbey]

Hi,

Thank you very much for your interest. An error was made in the SPI communication part. I may have misspelled the flash name. I'll talk to the hardware team again. Thank you again for your answer.

[BSTRobin]

Welcome, uuranbey.