BMA423 interface problem

[christeee222]

Hai, I am trying to BMA423 sensor interface with CC26xx series.  I read the chip Id.  Hereafter I cannot do the further steps. It's necessary to include the config file contains 6145 commands.  what are the steps to be followed? Please help me & I am the last stage of my project in college days.

[o_o · Accepted solution]

Take a look at our repository on GitHub: https://github.com/BoschSensortec/BMA423-Sensor-API

It has all the information needed to use the part.

[christeee222]

Yes, I am trying the same project files with my application code. But, When I am writing the config.  file, the status which I want to read from the register 0x2A is 0x01 hex value. This status is not obtained. Kindly help in this regard. ( I am using CC26xx controller which is RTOS based)

[o_o]

Could you please share a datalog of the bus activity to make sure that the communication protocol is followed?

[sadasivam]

Hi, this is sada. I am facing the same issue regarding interfacing in I2C mode. Here is the log which I have tested.