09-15-2021 09:56 PM - edited 09-15-2021 10:35 PM
Hello together,
I just got a new, preprogrammed BME 688 development kit.
If I connect a USB power supply the yellow LED starts flashing. A moment later the red LED blinks 5 times, pauses a while then blinks 5 times again pauses and so forth. However even if I wait several minutes I don't find any data on the SD card except the default config file.
Do I need to do any additionals steps e.g. press a button? I didn't connect the Android App so far.
Thanks in advance,
Tom
Solved! Go to Solution.
03-20-2023 09:25 AM
We got also 4 dev kits as "preprogrammed" but no one had the Arduino sketch on board. You had to do it by your own, best you take the binary from Bosch's software repo.