BME680 load state from another sensor

[Cris]

Is it possible to load the state taken from another BME680 sensor after it's calibrated and copy to a new board? Since it take a long time for a sensor to get the first calibration (IAQ accurancy = 3), is it possible to take the state as it is saved from the sensor 1 (usually after 8 hours after turn on) and copy to the sensor 2 to simplify the production and calibration? Will the calibration of the sensors be the same?

Thanks,

Cristian

[handytech · Accepted solution]

Each calibration profile is unique based on BME680 device-specific properties but also relevant for the history of air mixtures observed by that same device. Therefore it is unfortunately not possible to share one state string across multiple sensors.