Hi all,
I just bought a BME688 dev board and was buying a huzzah32 to be able to use it. Looking for the huzzah32 I found that esp32-s3 is also available in the same format. Would it be possible to use the dev board with the esp-s3 feather board?
Thanks,
Danilo
Hi Wololooo,
Yes, you could refer https://community.bosch-sensortec.com/t5/MEMS-sensors-forum/BME688-BSEC2-for-ESP32-S3/m-p/61956 to get BSEC library for ESP32-S3.
Thanks for the reply.
I had already found that post and now I realize that I should have been a little more specific: would it be possible to use the development board with BME-AI Studio using the esp-s3 feather board?
If so, are there any changes to the code to upload on the esp?
Thanks
Hi Wololooo,
The BME AI-Studio Desktop enables sensor configuration, data analysis & labelling, training and optimization of application-specific solutions. BME AI-Studio didn't directly work with ESP320-S3.