06-24-2021 08:53 AM
Hello,
We are using BME688 sensor with nrf52840 controller.BSEC library used is having version 2.0.6.1.
We are facing problem with getting output using bsec_do_steps. Configuration file used is "bsec_sel_iaq_18v_4d" and mode set is HIGH PERFORMANCE mode.
Calling bsec_do_steps API at every "bsec_bme_settings.next_call" interval gives return value 5 i.e BSEC_W_DOSTEPS_GASINDEXMISS
Can anyone help why we are facing this issue
Thanks
06-24-2021 09:20 AM
Hello jadeja14890,
You could see "BST-BME688-Integration-Guide-AN008-06.pdf" under BSEC 2.0.6.1 package, and check step by bstep if you have correct SW integration.
06-25-2021 01:02 PM
Hello Robin,
Thanks for your response
Yes we are referring to the same guide that you mentioned in your reply and still we are facing this issue.
07-12-2021 11:47 AM
Hello jadeja14890,
We could discuss it in https://community.bosch-sensortec.com/t5/MEMS-sensors-forum/Not-able-to-get-Gas-Estimate-Channel-X-f...