I have been working with the BMX160, specifically the accelerometer and gyroscope. I have configured both these sensors as per my desired settings, and can successfully stream data from them. However, I am having a problem with the fast offset calibration (FOC), specifically with the gyroscope. When I enable FOC for accelerometer only, FOC works, but if I try to run it on both accelerometer and gyroscope, or even just gyroscope, it fails.
I have attached an example of how I have set up the device.
I have also seen this post, which describes the same problem I am seeing and has not been answered:
Like that user, if I go into the driver and increase the timeout, the FOC will succeed, but that seems to suggest that the spec sheet, and therefore the driver, may be incorrect as to how long FOC takes, at least for the gyroscope. Can someone please confirm or deny if I am correct in my conclusion that the datasheet and driver are wrong in this instance?
Solved! Go to Solution.
Thanks for your feedback. We will update data sheet and sensor API later.
Kindly note: BMX160 will be discontinued in the future, not recommended for new designs. You could select other part from selection guide according your application. https://www.bosch-sensortec.com/media/boschsensortec/downloads/promotion_material/product-selector-e...