There is some internal reference code for FW upgrade.
Please contact your local FAE for those code and steps on how to upgrade BNO055 FW.
Hi Vincent,
I am also keen to upgrade my BNO055 via my own MCU.
Can you please provide more information on how I can achieve that?
I haven't burned the final PCB yet, so I am quite flexible to expose pins.
thanks
For HW design, it is simple, just make the nBOOT_LOAD_PIN to be controlled by your MCU. When this pin was pulled low, sensor will enter boot loader mode and allowed MCU to write down the new FW into sensor.
For more detail on how to program the FW into sensor is restrict information.
Hi Vincent,
Thank you for your quick reply.
I contact Bosch support using the link you shared.
It seems, they are not very responsive. Probably takes couple weeks until they find my email 😄
Just have a quick question,
As I understood, if I connect BOOT & RESET pins (BNO055) to MCU, I would be able to update the firmware via I2C later time
Kind regards, Reza
Yes, you are right.
BTW, where are you located? maybe you can send me the pravite mail in the Community. then i can try to see if i can speed up this. 🙂