05-08-2021 08:02 PM
I am planning to use your product BNO055 9-Dof IMU sensor in a project that I am currently developing. I read the data sheet and found a lot of necessary information I was looking for. Thank you first for this. But I want to run this sensor in Simulink part of matlab. There is a BNO055 function there, I tried to read the data using it, but I could not read the data. Would you help me with this topic ? (How can I do that?)
I connected the IMU to the Arduino, then the Arduino to the computer. I opened the flask and made the necessary adjustments, but somehow I could not read the data with a graph in Simulink.
05-10-2021 07:23 AM
Hello mambocha,
Are you just reading sensor data in Simulink simulation? Instead of reading sensor data on the sensor hardware? The usual way is to get sensor data from real hardware.