11-22-2021 04:18 PM
Hi all, I was searching for an alternative to the "restore offset" of a BNO055. I used it with an arduino uno wifi rev 2 and It worked properly! Right now, I switched to the portenta h7 board where the eeprom is not included as library. Is there the an alternative way to create a process of store and upload calibration after each restart without using eeprom?
Thank you so much
11-23-2021 06:51 AM
Hello Django,
Do you mean you would like to find a way to save calibration profile?
11-23-2021 09:59 AM
Goodmorning, in the end what I asked is if there could be an analogue way of "restore_offset.ino" that doesn't use the eeprom library.
11-25-2021 07:22 AM
Hello Django,
You could also store calibration profile in Flash memory according your hardware memory resouce.