05-04-2022 03:01 PM
Hi there,
I have a question about specs for the BNO055 sensor. Table 0-1 of the datasheet specifies Voh, Vol, Vih, Vil, but only for UART & I2C. I found nothing in the datasheet that specifies levels for pins like nRESET, INT, nBOOT_LOAD_PIN, BL_IND, etc. But maybe I missed something.
Table 5-1 basically says that the UART/I2C signals (COM0-COM1) are of the same type as nBOOT_LOAD_PIN, BL_IND, etc (e.g. "Digital out", "Digital in", "Digital I/O"). So maybe this hints that the I/O voltage levels are the same. But I'd rather see it stated in black & white, if possible. Especially since pins like nRESET are listed as being of type "--".
Does anyone know where I can find this information? I tried a live chat with Bosch but that wasn't helpful, no offense intended.
Thanks!
Steve
Solved! Go to Solution.
05-04-2022 03:45 PM
Hi SVK,
Normally, they had same characteristic for non-supply pins as they had same VDDIO supply.
05-04-2022 03:49 PM
Thank you for the information - I appreciate it. I'm assuming that by "non-supply" pins you mean the unspec'd pins I was referring to like nRESET, BL_IND, etc. (i.e. the non-UART/I2C pins). Is that correct?
Thanks,
Steve
05-04-2022 04:02 PM
Yes, SVK.
05-04-2022 04:26 PM
Perfect. Thank you!
Steve