BNO080 interfacing with ESP.

[rdDev]

hi

I have worked with BNO055 and now have tried using BNO080. I am using the i2c protocol for interfacing these sensors with my MCU.

I successfully interfaced BNO055 with Arduino, NodeMCU, ESP32, STM32 board.

So, when I gave a similar try to BNO080, I was successful in interfacing it via Arduino and ESP32. However, the sensor didn't work with NodeMCU and ESP Wroom-02.

So, can someone tell me, what's the issue here, when BNO055 was able to run on NodeMCU why BNO080 isn't working?

Have checked the i2c transfer rate on the sensor and max ability of ESP8266. (400Khz and 100Khz- I have kept both same.)

Any help would be really appreciated. I just want to interface BNO080 with ESP8266 (NodeMCU or ESP-Wroom-02).

Thank You.

[elrhoul · Accepted solution]

Dear rdDev,

The BNO080 was developped in collabation with Hillcrest Labs, they provide the Software in this device and their are responsible for supporting. so please contact hillcrest they can support you on this issue.

Regards

[tareksmabr]

Can you please share the codes you used in Arduino, NodeMCU, ESP32, STM32 board.

Can I use the Bno055 and Arduino to control stepper motor and servos like flight stabilizer?

[Nikhil]

Can you share source code for stm32