BSEC 'C' example code based on Arduino-IIC

[Hello_Sensor]

Hi all,

I wrote a code for running BME sensor based on Arduino IIC.

But when i subcribe 'raw_gas' i can not get any new data, in contrast, when i don't subscribe it, which can output T/P/H successfully, could someone help me to review my code. (I'm using BSEC 2400)

Thanks.

[Minhwan]

Hello,

Please run with BSEC_SAMPLE_RATE_LP mode , not CONT mode for IAQ. 

Also, I found that watchdog value is 2000, I guess 2s. 

Please increase wdt value like 5s just in case. Our LP mode is 3s interval. 

Thank you.  

[Hello_Sensor]

Hi Minhwan

I just wanna measure the gas, not IAQ, anyway, i also try to use LP, the same result as the above.

Thank for your reply.