Breakout board for plugging shuttle board 3.0 sensors into a breadboard

[JamesMeech]

I am looking for an easy solution to plug the BMP581 sensor shuttle board 3.0 into a breadboard, is there something that you can recommend?

I don’t want to use the Application Board 3.0 because I want to use my own microcontroller with the sensor

[FAE_CA1]

Hi,

Thanks for your inquiry.

Shuttle board 3.0 has 1.27mm pitch male headers. The easy way to connect BMP581 shuttle board 3.0 to a breadboard is use some kinds of male/female jumper wires that are compatible with 1.27mm pitch. Or you can design and make your own adapter board to convert shuttle board 3.0 connectors to DIP-16 (8 pins on each side) with 2.54mm pitch for the breadboard.

Thanks.