HI, I hope you are fine and safe,
Development Desktop 2.0 not working for Arduino UNO
this is my problem when I want to connect Arduino UNO that I connect BME 680 Shuttle board on it, to the desktop Development bosch software v2.
My question is: is it possible to connect Arduino UNO to this desktop software?
I used to port, com3, and USB, both of them were not working.
Solved! Go to Solution.
Re: Connecting Arduino UNO to Desktop development v2
Hi thanks for reply,
do you know how can I calibrate the BME680 (hardware calibration)?
I mean I connect this with Arduino UNO to Arduino desktop and receive output data,
But I am not sure about that data is true or not,
I wanna put in the special case and left it to indoor place for 3 days and after that compare the results,
So is it need to calibrate it or not?
I use DEFrobot SEN0248.
Do you mean IAQ calibration? There is a similar question as bellow, please view it fist.