I am working on a project to interface BME688 with nrf52 chip, I am using BSEC lib v2.
I am able to read data from the sensor, to validate my data whether I have corrently interface the sensor or not, for this reason I have used another MCU ESP 32S , A example code is provided in library pakage I have used the example code.
while comparing the data for two MCU's from the sensor, strangely I found that all the readings are similar except Gas Resistance.
as you will see in screen shot.
The ouput for both MCU is attached here with question.
I found that ESP-32S showing high gas resistance compare to the NRF52.
bsec_serilized_configuration_iaq.h is used for both MCU's.
I am unable to find the reason for this, what could be the possible for reason for this conflict?
You can see IAQ accuracy is 1 from your output.
It need some time to finish the calibration until accuracy reach to 3.