Handle custom relative orientation between BHI260AP and BMM150

[Gianlucamilani]

Dear Community,

I included BHI260AP + BMM150 magnetometer in my custom PCB design. 

Due to space constraints, I mounted the two devices in opposite layers (BHI260 AP top, BMM150 bottom)

The relative orientation of the two devices is the following:

Top layer (top view): you can see the BHI260AP with the pin 1 indicated in blue

Bottom layer (top view: seen from top): you can see the BMM150 with the pin 1 indicated in green

My question is: how to take into consideration this aspect? where can I configure it?

Thank you very much,

best regards

Gianluca

[Gianlucamilani]

Thank you very much for the answer. 

Best regards

Gianluca

[BSTRobin]

Welcome, Gianlucamilani.