Hi.
If I want to check the accuracy of angular velocity and acceleration measurements, which part of the datasheet should I look at?
Is it the same as the description of max or min sensitivity (or resolution)?
And, I would also like to know the accuracy of angular velocity and acceleration when repeated measurements are taken after offset.
I know this is a rudimentary question, but I'd like to know.
Solved! Go to Solution.
Hello yasu_999,
You could refer the chapter "1.2 ELECTRICAL AND PHYSICAL CHARACTERISTICS, MEASUREMENT PERFORMANCE" in BMI160 data sheet.
Hello BSTRobin,
Thanks for your reply.
I read the datasheet and understood the following, is it correct?
""
Without considering external disturbance, the accuracy of 1 bit of measurement at 25 degC and 16G range is determined by the reciprocal of sensitivity, 1/2130~1/1966.
And, the temperature and overvoltage supply will cause changes in the accuracy of the measurement.
""