If I want to check the accuracy of angular velocity and acceleration measurements, which part of the datasheet should I look at?
Is it the same as the description of max or min sensitivity (or resolution)?
And, I would also like to know the accuracy of angular velocity and acceleration when repeated measurements are taken after offset.
I know this is a rudimentary question, but I'd like to know.
Solved! Go to Solution.
You could refer the chapter "1.2 ELECTRICAL AND PHYSICAL CHARACTERISTICS, MEASUREMENT PERFORMANCE" in BMI160 data sheet.
Thanks for your reply.
I read the datasheet and understood the following, is it correct?
Without considering external disturbance, the accuracy of 1 bit of measurement at 25 degC and 16G range is determined by the reciprocal of sensitivity, 1/2130~1/1966.
And, the temperature and overvoltage supply will cause changes in the accuracy of the measurement.