Not able to get Gas Estimate Channel X from BSEC

[jadeja14890]

Hello All
Goof Day!!
We are integrating BSEC library with BME688 sensor on NRF SDK ,
We succesfully able to get compensated Temprature , Humidity,Pressure value from BSEC
But we are facing issue to get Gas Estimate X out from BSEC,it always show zero value even after 45 minute of test run.
And also IAQ value always show 25 and "Run in status"  flag always show 0 from BSEC output.

Please suggest possible solustion of issue.

Please find detail log in Attachedment

Let me know if more information require.

[BSTRobin]

Hello jadeja14890,

Could we know more detailed software information? Like software version, which example code you use...

[jadeja14890]

Hello  BSTRobin,

We are using BSEC version 2.0.6.1 and we refer arduino example and bsec.cpp  that comes under bsec library.

let  us know if more information require.

Thanks

[BSTRobin]

Hello jadeja14890,

Thanks.

If it is ok, could you provide you arduino code, we would like to check it.

[jadeja14890]

Hello BSTRobin

Can you share your email ID , so we will share code and config file over mail ,as  per company policy can not share propietry code over public forum.

Thank you