Power Audit

[desarmador2020]

I have the BME688 X8 and the Huzzah feather boards. I need to do a power audit so I want to disable all BME688 sensors and enable them one by one. How do I do this? I have checked the documentation and examples and even in AI Studio I can't find how to do this.

[BSTRobin]

Hello desarmador2020,

You could see the schematic of BME688 Adafruit HUZZAH32 feather board, all BME688 sensor could be individually accessed as they shared same SPI bus but were enabled/disabled by different CS pin.
https://www.bosch-sensortec.com/media/boschsensortec/downloads/product_flyer/bst-bme688-fl001.pdf