Remap axis bmi160

[GMarco_Utech12]

Good morning,

I development a board that comuncation with the BMI160 sensor. I would like to run rempap of the axis and sign. Which the command i must using ? 

Thanks you,

[GMarco_Utech12]

can you please indicate me the command header to remapping the axes from BMI160 sensor ? that i can't find it.

thanks you

[FAE_CA1]

Hi,

Sorry. I don't know why the attachment did not go through. I attach it here again.

Thanks.

[Vincent]

I don't know why attachment is not showed here.  i captured one image here. 

[GMarco_Utech12]

i'm Sorry, i don't good explained, but i would like to remap the axes via firmware sending a command, for example 'ACC_INT_Settings 0x12' (manual 'BMI160-DataSheet.pdf' ) that i sendig to enable gli interrupt. But i can't i found the command to remap in to BMI60 datasheet. Can you help me ?

I m development also BNO055 sensor e i can remap the axes with the header command 0x41 (manual 'BST_BNO055_DS000_14.pdf').

thanks you

[Nikosant03]

Hi Vincent

Could you share the "BMI160 shuttle board 9-axis sensor orientation v1.1.pdf" or provide a link?