Request BSEC 2.2.0.0 for ESP32-C3

[Joris]

Hi,

The GitHub repo, https://github.com/BoschSensortec/Bosch-BSEC2-Library , has advanced to 2.2.0.0

Can you provide this version, 2.2.0.0, with matching generic config files for ESP32-C3 ?

Best,

Joris

[BSTRobin]

Hi Joris,

You could refer another topic https://community.bosch-sensortec.com/t5/MEMS-sensors-forum/BME-680-BSEC-for-ESP32-C3/td-p/54638/pag... to get BSEC2 ESP32-C3 library.

[Joris]

@BSTRobin 

I'm aware of that topic. I've even replied mutiple times there.

But, the ESP32-C3 version in that topic is older. I would like a 2.2.0.0 version, with matching generic config files, for the C3 variant.

Best regards,

Joris

[BSTRobin]

Hi Joris,

Thank for your feedback.
I will discuss the release of the latest library with the internal team.

[Joris]

@BSTRobin 

I've noticed the commits in the  Bosch-BSEC2-Library on GitHub. Thank you for including the ESP-32-C3 version!

I've done some test with the 2.2.0.0 BSEC library (Arduino via Esphome) and have a few questions:

1. Temperature readings are not very stable when using BSEC library. When I use the old, non BSEC, library I can turn the internal heater off, which results in a far more stable temperature readings. I assume the jitter comes form the internal heater. Is there a way to turn the heater off when using the BSEC library, or will this feature be implemented in a furure BSEC version?
2. Do you have generic config files for the 2.2.0.0 BSEC library? I use the sensor (BME680) at 3V3. I believe the sensor's config defaults to 1V8. The older BSEC library had those ( ref: https://github.com/boschsensortec/BSEC-Arduino-library/tree/master/src/config )

Best regards,

Joris