Use BME8x pushbuttons in AI Studio

[GDD]

When importing data from the micro sd card, the user was told to press either button to note the start of the capture and the end of a capture.

It would be nice if the BME AI Studio showed these markers and they coud be used to mark the start, or the end of a time. In this picture button presses aren't seen. Also, for STARTing I add time for the BME8x to warm up and skip the. time to transfer the. device to the specimen container. For Ending, I remove the time to get the device from the container and press the button.

Delay start, end cutoff times.

[BSTRobin · Accepted solution]

Hello GDD,

 You could refer detailed step in BME AI-Studio document "https://www.bosch-sensortec.com/media/boschsensortec/downloads/application_notes_1/bst-bme688-an001....".

[GDD]

So pushing ANY button causes automatic creation of a specimen. The specimens aren’t ordered as SW1, then SW2 but by time. So I can push the sw1 or the sw2 as there is no difference in how AI studio reacts to the data.

This is OK as AI doesn’t know if the button represents data just collected or data to be collected. Although it is stated for the upcoming data in the documentation.

My laptop is still at Apple.