08-27-2019 10:45 AM
Hello, there
I am learning the application note:bmf055 example project-data stream,and following the instructions step by step. But the terminal output is not shown as the note says. The sensor data is not displayed. Instead, regular messy codes appears on the terminal window.
The connection between the computer and MCU is linked by UART module instead of USART module.
Could you tell me why the messy terminal output appears and how to solve the problem?
Thanks a lot!
Solved! Go to Solution.
08-27-2019 04:43 PM
08-28-2019 11:04 AM
08-28-2019 01:46 PM
Is the baudrate set correctly?
08-29-2019 08:15 AM