Hello everyone. I bought a BMP280 sensor. I have attached a half-meter wire (on the I2C bus). The sensor works well. But now I want to place this sensor inside a freezer. Can I place the BMP80 breakout board directly inside the freezer, or do I have to make some enclosure for it?
(If I have to make an enclosure for it) Any design guidelines to design it?
Thank you for your help.
I want a similar thing like this:
Is this enough to design a similar 3D enclosure and place the BMP280 PCB inside it? (Does it affect the sensor measurements?)
In the above post. They designed a 3D enclosure and placed the BME280 inside that box. No membrane or similar thing is used.