Hello Robin, thank you very much for the answer. I was using the BSEC 2.x example, so this should be ok. Question 1 As you delete EEPROM part, BSEC config file willn't be loaded. Is that actually an issue? I read in the instructions somewhere to delete the EEPROM part, and it didnt work on my ESP32 anyway. I understood that the Sensor can save its state in there. If i restart my arduino, i will begin from scratch, right? Question 2 I did have another question regarding the outputs and timing of the BSEC 2.x example. I do get values for gas index 0-9 and with ne 9th index i get IAQ values. Is that the correct behavior? The timing is a little odd , i get some values regularly and from time to time it takes ~2 minutes for next measurement. I checked the xxx.next_call funtion return which is giving me actually a timestamp 2 minutes in the future. I am wondering if that is the correct behavior as well= Question 3 For IAQ measurements, do i have to change "bsec_config_selectivity" to "bsec_config_iaq", correct?
... View more