About Digisolve

Just to let you know I've updated the firmare. It's now 1.9. But I still canot do what I need to     ... View more

Basically I want to get the orientation information which is shown the General Settings -> System tab I'll explain what I have done & hopefully you can explain what i'm missing: Connected Application Board 3.0 & BHI260AP Shuttle Board 3.0 Installed & run Development Desktop 2.0 Downloaded Bosch_APP30_SHUTTLE_BHI260_aux_BMM150-flash.fw (dated: 16/05/2022 save: 115K) from C:\Program Files\Bosch Sensortec\Development Desktop 2.0\Firmware\BHI260AP\Flash Images Set Sample Rate to 25Hz for Acceleromter Passthough(Non-Wakeup) Set Sample Rate to 25Hz for Gyroscope Passthough(Non-Wakeup) Set Sample Rate to 25Hz for Magnetomoter Passthough(Non-Wakeup) Plot1 is already Acceleromter Passthough(Non-Wakeup) Changed Plot2 to Gyroscope Passthough(Non-Wakeup) Changed Plot3 to Magnetomoter Passthough(Non-Wakeup) Start Streaming and the plots get populated, but not the Orientation values Stop Streaming and press Refresh but get the error Host Download Channel Underflow(Host Read Too Fast) Slowed the Interface Selection -> Sensor Interface down to 1000Kbps, (I had to set everthing up again!)  Started & stopped streaming. This time the Refresh showed no errors, but the Orientation was still not populated   Here's the about box for my install of Development Desktop 2.0 Beta - BHI260AP (should is be Beta?) I just need to know exactly how to setup this dev system so I can evaluate the pitch/roll/heading performance in real time (just like I did with the BNO055) ... View more

Sorry I'm not clear. This only has a .C & makefile   ... View more

I've found the BHI260AP https://www.bosch-sensortec.com/products/smart-sensors/bhi260ap  which mentions the "BHI260AP shuttle board 3.0". This is fitted with the BHI260AP & BMM150. Also the BST-BHI260AP-FL000 https://www.bosch-sensortec.com/media/boschsensortec/downloads/product_flyer/bst-bhi260ap-fl000.pdf talks about the Software feature saying "...support for increasing number of activities without the need to modify the original software." Does this suggest the device is already programmed with this software. Or is the software stofed in off-chip FLASH (which is also fitted to the "BHI260AP shuttle board 3.0"? I want to buy an evaluation board which will (hopefully) plug-n-play so I can evaluate the funtions & performance without having to spend lots of time & effort installing & learnig new dev tools. I know I may need to do this going forward, but it this stage I need a to evaluate your solution & demo this to my customer so we can be sure it performs to a level acceptable to my customers requirements. ... View more