About mgchoi

Hi, FAE_CA1 Thank you for your reply. I have a few more questions, can you answer them? 1. What is tap_th<4:0> the set range value at 62.5mg e.g. at 0x10?      The same applies to slop_th <7:0>3.91 mg (2-grange). What is the slop_th at 0x10? 2. What is the sampling time after sleep time at bandwidth 1000Hz?   ... View more

Hello I have a few questions, so I'm leaving a reply. 1. Does the Single tap function react to all x, y, and z axes? (ex. Does it react to tap from above when the sensor is standing 90 degrees from the floor?) 2. Regarding 2-16g, I know that the lower the range, the more resolution it provides for slow motion, and the higher the range, the better for fast tracking, but is 16g better for detecting small vibrations? ... View more

  Interrupt does not occur even if set to 1KHz. ... View more

Hi, BOSCH I set it up in the way you sent me during the test with DD, but there is no interrupt. What kind of setting is needed for this part?       ... View more