About o_o

Do you have a similar spreadsheet for the BMP390? Your Temp parameters worked great - I was able to get that working fine. But, have the pressure parameters changed from BMP380 to BMP390? Thanks for supplying the sample calculation! Regards, Todd Anderson (A new user of the BMP390) ... View more

Hello I would like to know if there is any update in the fusion mode that will allow at least 8g to be used during fusion mode The datasheet in page 26 has the register for the range free of any restrictions, but on page 21 previously it says that the range is forced to 4g I believe that page 26 should also say auto-controlled in fusion mode. It would be nice if we can have the 8g range in fusion.     ... View more

Hello Sir,  I m facing the same exact  issue with my Lenovo D330 . after installing fresh windows and installing all the drivers, Bosch sensor seems to be broken and not working..with the same error descrivbed above .. Kindly help me out with some fix.. That would be of great help.. Thank You.. screenshot ... View more

I am trying to reference my altitude measurement to nearest weather station's air pressure report. however, I believe I still need to calibrate BMP barometer first to an absolute reference.  any one has experience on how often this calibration needs to be done? can I do a factory calibration and use the result for the life of the product which might be 5-10 years? I intend to use BMP581 in my design. much thanks Leo ... View more

Any news about this? The BNO055 sensors purchage in 2021/2022 already came with this new firmware correction?  If I read Accelerometer registers in FUSION MODE the g-range is fix (+-4g) right? And the sensitivity is 1LSB/mg? And what about NO FUSION MODE? If I read the registers the sensitivity is also 1LSB/mg (the MCU inside BNO055 make sure this don't change) or in NO FUSION MODE te sensitivity is 2^14/(g-range) ?? ... View more