Bosch Shared
- Top Results
See all results
- About Swingpro
- About Swingpro
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
since
04-25-2019
2 weeks ago
Swingpro
New Poster
31
Posts
0
Likes
0
Solutions
06-26-2021
05:01 PM
If the accelerometer and gyroscope don't require the installation of initialization file to take readings - what step is required to get the 270 out of Suspend Mode and into Configuration mode? Section 4.4 of Data Sheet says "After every POR (Power on Reset) or soft reset, the IMU remains in suspend mode". Same section it later says "After the initialization sequence is completed, the power mode is automatically set to "Configuration Mode". How does one get the device into Configuration Mode without loading the initialization file? Is there a minimum set of instructions that can result in device exiting Suspend mode?
... View more
06-15-2021
03:59 AM
Has anyone gotten BMI270 to work using just Python (not COINES Environment)? I am trying to use a program based on BMI160, converted to the 270 and I can't get sensors to turn on. Power register indicates accelerometer and gyroscope turned on, and have set the full scale reading but sensors just do not provide readings. Any ideas?
... View more
04-22-2021
05:28 PM
Is there a way to see the actual commands setting various registers in the API. I am using Python without the COINES environment. I am able to read registers and write to registers but Temperature, Accel and Gyro don't return any values even though they are enabled in power register
... View more
04-14-2021
04:48 AM
Unfortunately the APIs don't explain exactly which flags are being set and are required to make readings possible
... View more
04-13-2021
01:13 AM
What are the minimum steps required to get the accelerometer/gyroscope to turn on so I can read measurements from their registers? I was told elsewhere the initialization file isn't required if I just want to make register reads. If I follow the "Configuring the device for normal power mode' Page 19 of Data Sheet: 7D = x0E 40 = xA8 42 = xA9 7c = x02 All I get are '0's for both Acceleromer and Gyroscope. I can read chipid, temperature and sensortime so my read and write statements are working Same with Sensor self test for Acceleromer and Gyroscope - just get all '0's. What am I missing?
... View more
Latest Tags
No tags yet
Still looking for something?
- Top Results
See all results