Bosch Shared
- Top Results
See all results
- About super_mcu
- About super_mcu
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About super_mcu
since
03-04-2021
03-17-2021
super_mcu
New Poster
4
Posts
0
Likes
0
Solutions
03-15-2021
07:29 AM
Hi Yanchao, Also, there is no description about registers 0x78, 0x79 and 0x7A in the BMI270 datasheet (two versions, see below). Could you pass me some datasheet description of registers 0x78, 0x79 and 0x7A? Thanks. BMI270 - Data sheet Document revision 1.1 Document release data May 2020 Document number BST-BMI270DS000-03 Document revision 1.3 Document release data Nov 2020 Document number BST-BMI270DS000-05
... View more
03-15-2021
07:03 AM
Hi Yanchao, Thanks for your help. Yes, I got the gyro gain values from 0x78, 0x79 and 0x7A now. I wonder how to interpret the these values into Sensitivity Scalar? Thanks.
... View more
03-07-2021
11:53 PM
Hi, Yes, the CRT is done and success by verifying GYR_GAIN_STATUS.g_trig_status. But the reading value of GYR_GAIN_UPD_1, GYR_GAIN_UPD_2, GYR_GAIN_UPD_3 in page 1 are always "0".
... View more
03-04-2021
12:48 AM
After a success CRT (GYR_GAIN_STATUS.g_trig_status reports a successfull CRT run), I tried to get the new gyro gain values from below locattions: - register 0x78, 0x79, 0x7A - GYR_GAIN_UPD_1, GYR_GAIN_UPD_2, GYR_GAIN_UPD_3 in page 1 But all values are "0". I wonder how to get the new gyro gain values, wihch will be programmed to NVM later. Thanks.
... View more
Latest Tags
No tags yet
Still looking for something?
- Top Results
See all results