Bosch Shared
- Top Results
See all results
- About DRA
- About DRA
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About DRA
since
08-04-2021
12-13-2022
DRA
New Poster
7
Posts
0
Likes
0
Solutions
11-24-2022
03:16 PM
Is my concern or a part of my question unclear? I am happy to provide additional information on our scenario if that helps answering my question.
... View more
11-22-2022
06:27 PM
We are looking into integrating an electronic compass into our system. After testing the BNO055, it appears, that the system cannot be used in a completely static scenario, if absolute heading is necessary directly after system start-up. Let me explain: In our scenario, it is necessary, that the system can be calibrated in fab or another suitable location and can then provide reliable absolute (!) heading data directly after system start-up, without moving or rotating the system what so ever. The problem with the BNO055 in this scenario is, that even though the sensor is configured with calibration data (which was stored when the calibration status was all 3s) and some absolute-heading fusion mode, the heading is mostly zero or way off (~100 degrees and more) until the system is moved and rotated a bit. Is there a sensor solution from Bosch that is suitable to our scenario? Thanks and all the best!
... View more
07-27-2022
12:15 PM
The datasheet of the BNO055 holds an extensive section about axis remapping, however, I struggle to find a definition of the heading: Given the sensor is configured in P1 axis map (which is the default), which axis needs to be parallel to true north direction in order for the sensor to indicate 0° heading?
... View more
11-04-2021
04:51 PM
Hi everyone! Is it possible to use historic, i.e., saved calibration data when using the BNO055 with BSX-Lite? We want to avoid having to do the calibration routine after every power cycle. Thanks!
... View more
08-10-2021
10:40 AM
Hi! ad 4.: Does BSXlite host side fusion software support disabling of continous calibration? ad 5.: The read arrow in the figure denotes positive X axis. 6. How is HEADING defined? Is it the angle between configured sensor positive X axis and true north?
... View more
Latest Tags
No tags yet
Still looking for something?
- Top Results
See all results