Hello, I'm using BME688 (8x) sensor board and BSEC2.0 lib running on ESP32 to read sensor data. I'm using the original Arduino code provided with the BSEC2.0 lib (basic_config_state.ino) (only small adaptation in SPI read/write routines were made in order to comminicate with one from 8 available BME688 sensors) The general comminication (reading/writing registers) is working properly, the BSEC2.0 lib periodically reports new values, but after a (very) long run, the read values are far away from the current environment values and the accuracy still remains 0 (unrelaible): timestamp = 23736544 iaq = 112.88 (acc: 3) temperature = 36.09 (acc: 0) pressure = 100595.15 (acc: 0) humidity = 25.06 (acc: 0) gas resistance = 384528.72 (acc: 0) initialal stabilisation: FINISHED power ON stabilisation: FINISHED compensated temperature = 33.09 (acc: 0) compensated humidity = 29.55 (acc: 0) gas estimate 1 = 0.00 (acc: 3) gas estimate 2 = 1.00 (acc: 3) gas estimate 3 = 0.00 (acc: 3) gas estimate 4 = 0.00 (acc: 3) gas index = 9.00 NOTE: as a configuration the default bsec_serialized_configurations_selectivity.h and BSEC_SAMPLE_RATE_HIGH_PERFORMANCE is used. Any suggestions what here might be wrong? BR's -vitali
... View more