About Crackl1ng

Hello Crackl1ng, You could debug step by step to see where the error is reported in the following functions. ret = bsec_iot_init(BSEC_SAMPLE_RATE_LP, 0.0f, bus_write, bus_read, sleep, state_load, config_load); ... View more

Hello Crackl1ng， Could you only run original example code and see the output data from BSEC? void output_ready(int64_t timestamp, float iaq, uint8_t iaq_accuracy, float temperature, float humidity, float pressure, float raw_temperature, float raw_humidity, float gas, bsec_library_return_t bsec_status, float static_iaq, float co2_equivalent, float breath_voc_equivalent) { PDEBUG("timestamp=%lld, iaq=%f, iaq_accuracy=%d, temperature=%f, humity=%f, pressure=%f, \ raw_temperature=%f, raw_humity=%f, gas=%f, bsec_status=%d, static_iaq=%f, co2_equivalent=%f, \ breath_voc_equivalent=%f\r\n", timestamp, iaq, iaq_accuracy, temperature, humidity, pressure, \ raw_temperature, raw_humidity, gas, bsec_status, static_iaq, co2_equivalent, breath_voc_equivalent); } ... View more

Welcome, Crackl1ng. ... View more