I am running code based on the 'basic_config_state' sketch with additional outputs specified and capturing the outputs to charts. This is the Generic code not the x8 code ... I am using the BSEC2 library having found that calibration status > 1 was not achieved with the older library. This has been running for a few hours and run-in status is 1 while stabilisation status is 0. Questions, if I may, please .. 1. Temperature & Humidity Outputs For temperature and humidity readings, is it better to use the raw or compensated values? (I am seeing that the compensated values have not settled) 2. Configuration In the example, which includes detection of hand sanitiser, I've not found where the voltage (1.8 / 3.3) and heating time is defined. Also, I'm not sure what power mode this uses (e.g. LP, ULP). In the old library it was easier to see this from the choice of configuration file. Could you advise what 'mode' this uses? 3. Calibration Time Is there any way of getting an estimate of time to calibration? Currently STATIC_IAQ, co2 Equivalent and breath VOC are at 25, 500 and 0.5 respectively pending calibration competion. It would be useful to know whether calibration is improving or not thank you.
... View more