Hi guys, I am new to this and need some help. Thank you in advance. I have an application board 3.0 (APP3) with a BMP390 Shuttle Board 3.0 on it. I have installed Development Desk 2.0 (UI Ver 3.25.0.0) on Windows 10. My App3 is connected to my PC with Windows 10 through a USB cable. I can connect to the APP3 and DD2 displays the sensor main menu. (a graph show pressure and temperature) But I don't see any sensor output, just shows the main page of the (pressure & temperature) display. I have done the following (step by step): still don't see any data. a. updated window driver and was able to recognize the USB interface and connect. b. update the bootloader from COINES\v2.7.0\firmware\app3.0\bootloader_update. c. updated the DelopmentDesktop_2.0_Firmware_v1.9.bin. from COINES directory. Still, I don’t see any action from APP3/BMP390. Just an empty main graph table with no data. Note: I did all this because, when I received the APP3/BMP390 the boards were not showing any data and after all With these updates, the situation has not changed. I am lost and need some help. 1. Both LEDs on my app3 are lit, orange(good pwr), and RED. is this right? Should RED be GREEN? 2. When I try to update flash from DD2 bootloader menu with Blue LED on. using DD2 in Boot mode, ‘Setting’ -> ‘Firmware upgrade’ menu. using file “DevelopmentDesktop_2.0_frimware_V3.5.fwu2” the system indicate “Firmware update in progress...BUT just sits in this position forever, meaning flash never completes updating. I have waited 1/2 hour and still no indication of what going on. Appreciate any help --- thank you
... View more