Bosch Shared
- Top Results
See all results
- About matteo
- About matteo
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About matteo
since
08-28-2023
3 weeks ago
matteo
Member
6
Posts
0
Likes
0
Solutions
3 weeks ago
Hi, thank you for your answer. I thought that in the IAQ mode the default 10 step temperature profile was used as well. Now it's clear why only one data is given. Thank you. Best
... View more
08-06-2024
12:43 PM
Thank you. However i can't understand where I can find all the 10 readings of resistence (one for each heater temperature step), because as written in the datasheet only one resistance value is returned from the BSEC. These readings should be used by the library to analysed the characteristics of the gas. Best
... View more
08-06-2024
12:31 PM
Goodmornig, I was uploading one of my project on a Nicla Sense ME and I got this message: Module: 1 Error Message: Operator new out of memory Location: 0x4ABF5 Error Value: 0x4 Current Thread: main Id: 0x20003168 Entry: 0x1D337 StackSize: 0xC00 StackMem: 0x200067C8 SP: 0x2000732C I never saw this error before during the previous uploads. I then finally sort out that the problem is the new version of the Arduino_BHY2 library (1.0.7) that was released last week. In fact, the problem is solved when I use the version 1.0.6.
... View more
07-25-2024
04:54 PM
Goodmorning, I want to test a BME680 with the BSEC on a STM32 microcontroller system and I have two question: Where I can find information about the standard heater profile steps in continous mode used by the BSEC? I see that one of the output is BSEC_OUTPUT_RAW_GAS and i was wondering when the resistence is measured during the heater steps. Thank you. Best, Matteo
... View more
03-10-2024
11:22 AM
Hi! I found some inconsistencies between the information reported on the Datasheet of the BME688 and the Integration Guide about the BSEC Output. In table 20 of the datasheet, it is mentioned that there is an output of the BSEC library which is called "Sensor compensated gas resistance". However, this output is not listed in the output of the BSEC in the integration guide. Does anyone know which information is correct? Thanks.
... View more
Still looking for something?
- Top Results
See all results