Hello, I am following the steps for CRT calibration as mentioned in https://www.bosch-sensortec.com/media/boschsensortec/downloads/datasheets/bst-bmi270-ds000.pdf at page 68/105. After the final step I am reading the g trigger status and am getting an error code 0x01, precond_err, "Command is aborted. Pre-condition to the start of the feature was not complete." I can not finc any information on what all could be causing this error and as far as I can tell I am following the steps outlined. Can I be provided more information on what the error code means or what causes it? Thanks
... View more
