About fish

Vincent · ‎07-08-2020

Yes, they are identical if you put correct power mode value into configure data group already.

fish · ‎07-03-2020

Hi, BSEC do not support any sample rate except LP, ULP & DC. The sample interval for each mode is 3s, 300s, & 1s. This means when the customer modify the sample interval to 15 mins, BSEC consider always restart and keep run-in forever. Best regards.

fish · ‎07-01-2020

Hi, Congratulations! Would you please select Accept as Solution to close this ticket? Best regards.

fish · ‎06-30-2020

Hi, From bmp388 HSMI doc, you could find we suggest the hole in the top lid shall not be exposed to direct light. There are also some suggestion to avoid other factors influence. BST-BMP380-HS000.pdf, https://www.bosch-sensortec.com/products/environmental-sensors/pressure-sensors/bmp388/#documents

fish · ‎06-22-2020

Hi, 1、Can Bsxlite be used on bmi088 device? BSXlite support 9-axis, so you need prepare a/g/m sensor data. If you only need IMU fusion, please use BSX-Full. 2、 What is the accelspec/algospec/magspec about bmi088 in bsxlite? If you download BSXlite algo, you could find the relative guildline about using this algo. So what's the accelspec/algospec/magspec means? 3、The bsxlite ODR is 100Hz ,what is the input data rate? ODR is sensor's output data rate, directly feed to fusion algorithm. 4、Where can I get Bsx full? You could contact local distributor.

Bosch Shared

About fish

Re: BMX160 Power Mode - Transitions

Re: BME680 not calibrated when esp32 sleep for more than 5 minutes

Re: BMX160 on Raspberry Pi

Re: Pressure spikes in BMP388 data

Re: problem of bxslite library

About fish

Re: BMX160 Power Mode - Transitions

Re: BME680 not calibrated when esp32 sleep for more than 5 minutes

Re: BMX160 on Raspberry Pi

Re: Pressure spikes in BMP388 data

Re: problem of bxslite library

Still looking for something?