About BSTRobin

BSTRobin · ‎09-09-2021

Hello augusto1, Did you refer SW code in github? https://github.com/BoschSensortec/BMA456-Sensor-API/blob/master/examples/bma456/generic/fifo_full_header_mode.c

BSTRobin · ‎09-09-2021

Hello Russell-SIBI, Do you mean that your product uses a plastic shell? Does the plastic shell have an impact on the results of bme680? Or something else?

BSTRobin · ‎09-09-2021

Hello Swingpro, Sensor evaluation board was switched to application board 3.0. For application board 3.0, you could use shuttle board 3.0 with it. You could see it like this: https://www.bosch-sensortec.com/media/boschsensortec/downloads/shuttle_board_flyer/application_board_3_1/bst-bma456-sf000.pdf

BSTRobin · ‎09-09-2021

Hello Danj, If the gas curve of other smells are similar to coffee, it is likely that other smells can be identified as coffee. You could try to label more different smells and train the data to see if different smells can be classified.

BSTRobin · ‎09-09-2021

Hello AkmalSQ, Is there any error or warning code on your side? The example code in BSEC2 release package is verified and can be used for start up. Please make sure you used the bsec_serialized_configurations_selectivity configure string. And for selectivity solution, when gas estimated is requested, we can only use BSEC_SAMPLE_RATE_HIGH_PERFORMANCE, otherwise gas estimated will not be updated. Could you give feedback?

Bosch Shared

Re: BMA456 fifo_err flag not working

Re: BME688 and readings affected by 3D Plastic

Re: Application Board 2.0 Still Available/Supporte...

Re: BME688 ambiguous classification

Re: BSEC 2.0 + BME688 to detect BSEC_OUTPUT_GAS_ES...

Still looking for something?