Bosch Shared
- Top Results
See all results
- About prem111
- About prem111
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About prem111
since
07-25-2020
07-30-2020
prem111
New Poster
3
Posts
0
Likes
0
Solutions
07-30-2020
05:34 AM
How can I detect that there has been too much deviation and that my offsets have not been accepted? Of course, except for reading 0 degrees, because this can also be the case when it loads the offset correctly.
... View more
07-29-2020
03:50 PM
Thanks for reply. When writing x, y, z (LSB) offsets in CONFIG mode, sometimes it's ok and starts at x degrees (heading), sometimes it starts at 0.0 anyway, what's the cause? Of course, it only gives the magnetometer offsets, maybe there is a problem here? what to do when i don't know acc and gyr offsets?
... View more
07-25-2020
01:36 PM
Hi, I am going to use the bno055 sensor in my RC boat. Is calibration required each time it is turned on? Can't save previous calibration or provide parameters from outside? If this sensor is not suitable, which Bosch Sensortec offer would be suitable with heel compensation for my boat? I would like to add that the calibration would be rotated by 360 degrees. Thanks.
... View more
Latest Tags
No tags yet
Still looking for something?
- Top Results
See all results