Bosch Shared
- Top Results
See all results
- About mayor
- About mayor
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About mayor
since
10-21-2020
01-27-2022
mayor
Established Member
17
Posts
0
Likes
1
Solution
01-27-2022
12:35 PM
Interesting, I am on 1.4.8 and can't find a download on the Bosch site for V2. In any event, is there now documentation for the calibration registers? Are they writable?
... View more
01-22-2022
01:20 PM
Hi Minhwan, I had seen that function which takes into account factory "dev->calib.par_h*" parameters. There is no API or documentation (besides reverse-engineering the code in that function) to adjust those params. I'm not even sure they are writable? But even then, I use BSEC...
... View more
01-21-2022
12:42 PM
I have three BME680 sensors whose readings you can see below. They are in the same location, so I would expect readings to be within specified tolerances. You can see that the "yellow" sensor is off, especially with regards to humidity. I have not seen APIs to apply humidity calibration. Can this be done within the sensor, so that IAQ readings take it into account, and not as a post-reading calculation? Note the gas readings are also very different. This isn't confidence-inspiring, but I am willing to try whatever is suggested here.
... View more
11-05-2020
11:17 PM
Hi Vincent, they are two separate boards. Note that I am using the bme680 api, not BSEC at present. In terms of swapping the sensors, do you mean to actually desolder them and resolder on a diff board? I _could_ try that I guess, but it's a pain. I'll check the power rails first and let you know.
... View more
11-05-2020
12:07 PM
Had something similar. Turned out my i2c write function wasn't working as expected. Check the sensor's registers after configuring it to read hum, press and resistance... Do they match what you asked for?
... View more
Latest Tags
No tags yet
Still looking for something?
- Top Results
See all results