About DalesLandnet

BSTRobin · ‎08-21-2024

Hi DalesLandnet , Thank for your inquiry. BMA456 also supports any motion and double tap features in low-power mode without the need to reload firmware. When any motion or double tap events occur, the sensor will report an interrupt signal to the host to wake it up. Then the host read the interrupt status register of BMA456 to check which type of interrupt trigger (any motion, double tap, etc.) it is.

BSTRobin · ‎12-25-2023

Firstly please ensure your hardware was correctly setup. And refer to official BMA456 example code on Github(https://github.com/boschsensortec/BMA456-Sensor-API) and previous comments.

BSTRobin · ‎12-13-2023

Hi DalesLandnet, Please refer to temperature sensor SPEC in BMA456 data sheet. We didn't find there was 4 degrees difference.

FAE_CA1 · ‎11-27-2023

Hi, Thanks for the update. Glad to hear that you are able to get BMA456MM interrupts. Thanks.

Bosch Shared

About DalesLandnet

Re: BMA-456 Understanding interrupt status retention after wake-up.

Re: BMA456 example "motion" from BOSCH Sensor API doesn't register no motion/motion interr

Re: BMA456 Temperature sensor accuracy

Re: BMA456 Uable to get any of the any/no motion or tap interrupts to give a response.

About DalesLandnet

Re: BMA-456 Understanding interrupt status retention after wake-up.

Re: BMA456 example "motion" from BOSCH Sensor API doesn't register no motion/motion interr

Re: BMA456 Temperature sensor accuracy

Re: BMA456 Uable to get any of the any/no motion or tap interrupts to give a response.

Still looking for something?