Hi all,
I have a BME688 shuttle board (with huzzah32) and an Arduino Nicla Sense Me. I would like to know how to upload a configuration generated by BME AI-Studio onto the BME688 on the Arduino Nicla (passing through the BHI260AP I assume). I've been looking for a while but couldn't find anything.
Thanks, Danilo
BME AI Studio config on Arduino Nicla
Best reply by zgg
this might be too late, but you could refer to this: https://www.hackster.io/lucasguocn/use-bme-ai-studio-with-bme688-on-the-nicla-sense-me-board-5f1b55
hope it's still useful
7 replies
Resolved