Hi team,
We have built a PCB to get orientation data for our product using BHI260ap, BMM150, and the flash memory chip used in the shuttle board. When we connected our PCB to the application board 3.0 connector and uploaded the firmware using COINES(Euler example) the output didn't come as expected.
We connected the below pins to the application board 3.0,
VDDIO
VDD
CS (HCSB)
CLK (HSCX)
MISO (HSDO)
MOSI (HSDX)
GND
GPIO2/INT1
Above is the error message we got.
If you have a possible solution please contact soon.
Thank you.