I have installed the Datalogger firmware using the USB-DFU bootloader as per as instruction: https://www.bosch-sensortec.com/media/boschsensortec/downloads/application_notes_1/bst-dhw-an012.pdf
After updating, the Status-LED of the Application Board 3.0 is blinking red. Besides that, I cannot connect the board with the Development Desktop 2.0 using USB. Which was possible before the update. Thanks!
Could you take a clear picture for your board? And let us check it.
Datalogger firmware is not supported by Development Desktop 2.0 GUI.
You'll need to flash the firmware "DevelopmentDesktop_2.0_Firmware_v0.9.bin" located in COINES\v2.6.0\firmware\app3.0 folder
1. Put Application Board 3.0 in bootloader mode (by powering ON the board with T2 button pressed, Blue LED show glow)
2. Run update_dd_fw.bat
thanks. I have created a video for that.
Thank for your feedback.
COINES v2.7 software has been released, you could use the latest software and test it again.