03-01-2024 10:15 PM
Hello,
I have an application question regarding BME280.
Within the datasheet and accompanying Handling, soldering & mounting instructions; it is mentioned that no liquids should come in direct contact with the device. Do these units come with a standard cap (cover) on the tape and reel package? How is protection of the BME280 handled during standard PCBA wash process?
03-05-2024 08:37 AM
Hi DTS_User_PM,
There is no additional standard cap (cover) in the tape and reel package of BME280.
Whether to clean PCBA depends on the cleanliness of the soldering process.
If cleaning PCBA, it is recommended to apply a film on the opening of BME280 to prevent it from being affected.
03-06-2024 08:45 PM
Thank you for the response.
If the sensor has been exposed to PCBA wash.
Is there any reliability information available?
03-12-2024 03:22 AM
Hi DTS_User_PM,
If the component of the cleaning solution is anhydrous alcohol, the impact on the sensor is relatively small. If it is other components, we cannot predict the impact on the sensor, as we previously commented, we do not recommend directly exposing the sensor to cleaning solution.